1948 GMC - Gauges & Switches


Main Garage Car Shows Finished Photos Before & After Progressive Photos Existing Truck Shop & Tools Running Boards Truck Bed License Plate Rear Shocks Rear Brakes Electrical Wiring Gas Tank Bench Seat Glove Box Radio Dash Heater Gauges & Switches Page 01 Page 02 Page 03 Windshield Wipers Cab Vents Grill Radiator Hood Headlights Front Fenders Doors Cab Steering Wheel Transmission Forward Controls Engine Fuel Pump Drive Shaft Exhaust Starter Carburetor Brake Lines Front End Front Brakes Rear End Suspension Frame Cab Interior Wheels Oil Lines Rear Fender Rear Bumper Estimated Cost & Parts List DuPont Paints Helpful Links joey@joeysgarage.com		Here is a shot with the new stickers in place and the frame set down to see if the edges of the stickers show. The maroon paint on the center flaking off, with a plastic paddy knife and some scratching with the finger nail, the old paint was removed.
		Here is a shot with the glass and chrome bezel in place.
		The black foam that pads the bezel to the glass was ordered from Jim Carters. If I would of known what was going to be sent, I would of simply picked up some small backer rods from Home Depot. Its the same thing... Anyways, the padding is a bit thicker than what I wish for it to be so with scissors, it was split down the center and now it works fine.
		Here is the gauge in place... This evening it will be coming back out to do some final painting touch ups and to redo the center maroon area.

Previous Page - Next Page