1948 GMC - Front Fenders


Main Garage Car Shows Finished Photos Before & After Progressive Photos Existing Truck Shop & Tools Running Boards Truck Bed License Plate Rear Shocks Rear Brakes Electrical Wiring Gas Tank Bench Seat Glove Box Radio Dash Heater Gauges & Switches Windshield Wipers Cab Vents Grill Radiator Hood Headlights Front Fenders Page 01 Page 02 Page 03 Page 04 Page 05 Page 06 Page 07 Page 08 Page 09 Page 10 Page 11 Page 12 Page 13 Page 14 Doors Cab Steering Wheel Transmission Forward Controls Engine Fuel Pump Drive Shaft Exhaust Starter Carburetor Brake Lines Front End Front Brakes Rear End Suspension Frame Cab Interior Wheels Oil Lines Rear Fender Rear Bumper Estimated Cost & Parts List DuPont Paints Helpful Links joey@joeysgarage.com		Note: Not all areas of the fender was the clear coat sanded. With sharp corners and detailed areas, it is best not to attempt it. With my luck, I would burn right though the clear coat when polishing it out.
		In order to keep the fender steady when polishing it out, I elected to engineer a temporary stand to hold it steady.
		In order to keep the fender steady when polishing it out, I elected to engineer a temporary stand to hold it steady.
		In order to keep the fender steady when polishing it out, I elected to engineer a temporary stand to hold it steady.
		In order to keep the fender steady when polishing it out, I elected to engineer a temporary stand to hold it steady. Wish I would of done this to sand out the clear coat.
		Following the same procedures as when polishing out the cab, the fender is starting to look good.
		Fender now polished and ready to mount.

Previous Page - Next Page