1948 GMC - Drive Shaft


Main Garage Car Shows Finished Photos Before & After Progressive Photos Existing Truck Shop & Tools Running Boards Truck Bed License Plate Rear Shocks Rear Brakes Electrical Wiring Gas Tank Bench Seat Glove Box Radio Dash Heater Gauges & Switches Windshield Wipers Cab Vents Grill Radiator Hood Headlights Front Fenders Doors Cab Steering Wheel Transmission Forward Controls Engine Fuel Pump Drive Shaft Page 01 Page 02 Exhaust Starter Carburetor Brake Lines Front End Front Brakes Rear End Suspension Frame Cab Interior Wheels Oil Lines Rear Fender Rear Bumper Estimated Cost & Parts List DuPont Paints Helpful Links joey@joeysgarage.com		Detail photo looking thru front inner drive shaft
		Center u-joint. To remove the u-joints, using a cutting wheel, I cut the u-joint in three parts and then banged out each of the cups separately. This showed an easier move seeing the u-joints were to be replaced. Other wise with each blow of the hammer, you would be forcing to cups to move instead of only one.
		Drive shafts, front axle and tie rod after cleaning (setting on truck frame) waiting to be primed and painted.
		Drive shafts, front axle and tie rod after cleaning (setting on truck frame) waiting to be primed and painted.