|
|
||
|
Finished Photos Before & After
Existing Truck
Radio
Cab
|
||
|
Inside of cab after the first round of priming and
sanding. Any areas where I sanded through the primer down to the metal, after cleaning up I sprayed on a little self etching primer from a rattle can to help prevent rust. |
||
| Here is the dash and toe board... | ||
| The back side of the cab after marking any dimples; both high and low. | ||
| The back side of the cab after marking any dimples; both high and low. | ||
| Another shot of the inside of the cab. | ||
| After sanding down the areas that needed touch up, I went back and with either body filler or glazing putty, the problem spots were addressed. | ||
| Glazing putty to to touch up some of the low spots or pin holes | ||