1948 GMC - Cab - Page 31


Main Garage Car Shows Finished Photos Before & After Progressive Photos Existing Truck Shop & Tools Running Boards Truck Bed License Plate Rear Shocks Rear Brakes Electrical Wiring Gas Tank Bench Seat Glove Box Radio Dash Heater Gauges & Switches Windshield Wipers Cab Vents Grill Radiator Hood Headlights Front Fenders Doors Cab Page 01 Page 02 Page 03 Page 04 Page 05 Page 06 Page 07 Page 08 Page 09 Page 10 Page 11 Page 12 Page 13 Page 14 Page 15 Page 16 Page 17 Page 18 Page 19 Page 20 Page 21 Page 22 Page 23 Page 24 Page 25 Page 26 Page 27 Page 28 Page 29 Page 30 Page 31 Page 32 Page 33 Page 34 Page 35 Page 36 Page 37 Page 38 Page 39 Page 40 Page 41 Page 42 Page 43 Page 44 Page 45 Page 46 Page 47 Page 48 Steering Wheel Transmission Forward Controls Engine Fuel Pump Drive Shaft Exhaust Starter Carburetor Brake Lines Front End Front Brakes Rear End Suspension Frame Cab Interior Wheels Oil Lines Rear Fender Rear Bumper Estimated Cost & Parts List DuPont Paints Helpful Links joey@joeysgarage.com
		Here is the patch welded in place.
		After cutting down the welds on the patch, cleaning the underside of the cab, (right side only). I went to work with filler to finish out the outer cab corner.
		After three to four thin layers of filler were applied, sanding between each layer, the corner was finally ready to prime.
		There is the cab corner primed.
		Another angle looking at the reflections for areas that might need to be touched up.
		With the right cab corner finished it was time to move to the left side of the truck. Her is that corner showing all it's pretty rust spots.
		With a marker, marked around the areas to be cut out. At first I considered cutting out a small dent along with the rusted areas but then changed my mind. I figured it would be more work to cut away and weld in more metal than simply filling in the small dent.

Previous Page - Next Page